Apps
Easy to generate test pressure in the lab, workshop or on-site
can be used to test, adjust and calibrate various pressure measuring instruments
can produce pneumatic pressure from -95 kPa to +3.5 MPa

Features
Ergonomic design
Equipped with a trim valve for precise setup
Compact structure
Lightweight

Description
Apps
The pressure test pump can be used to generate pressure, allowing users to test, adjust and calibrate mechanical and electronic pressure gauges through comparative measurements. These stress tests can be performed at the laboratory, on-site or on-site measurement points.
Easy to operate
Connect the instrument to be tested and a high-accuracy reference meter to the pressure test pump, then start the test pump. After the test pump is started, the same pressure is applied to the instrument to be tested and the reference measuring instrument. In this way, the user can calibrate or adjust the meter to be tested by comparing the measured values ​​of the two meters under any given pressure condition. In addition, this type of pressure test pump is equipped with a trim valve, allowing the user to precisely adjust the output pressure of the pressure test pump according to the application requirements.
Use
CPP30 hand-held pressure test pump not only compact, but also can easily and accurately produce test pressures up to 3.5 MPa. The test pump can also produce a vacuum pressure of at least -95 kPa after switching to vacuum mode via the transfer switch. The maximum pressure or vacuum that the test pump can produce depends on the connected test capacity. In addition, the pressure test pump is equipped with a trim valve that allows the user to set the pressure safely and accurately. The reference meter is mounted directly on the top of the pump, while the instrument to be tested is connected via a connecting tube (0.5 m, included in the test kit) with G & Frac14; internal thread.