×
CPH7000 Portable Process Calibrator

Standard type

Suitable for hazardous areas

WIKA-Wireless
Apps
Calibration Services and Service Industries
Measurement and Control Lab
Quality Control
On-site calibration (also safe for hazardous areas)

Features
Manual pressure source: -0.085 … +2.5 MPa
Accuracy: 0.025 % FS (with calibration certificate)
Generate/measure 0...24 mA and DC 24V supply voltage
Large capacity data storage with high speed measurement
Calibration Assistant

Description
Overview
CPH7000 process calibrator is highly accurate and portable, suitable for calibrating pressure measurement equipment, pressure sensors and process sensors with analog. The Ex version of the CPH7000 can also be used with hazardous areas. In addition, the product can be used to check pressure switches and determine switch points, check transmitters, analog and test transmitters.
Design
CPH7000 can be optionally equipped with an integrated reference pressure sensor and manual pressure generator to produce a pressure of -0.085 ... +2.5 MPa. The product can simultaneously power and measure (or simulate) its output signal via an electrical module.
Features
This calibrator allows you to quickly and easily set up calibration procedures, as well as run pre-configured calibration procedures and automatically save measurements. The completed calibration process can be transferred to the PC via the WIKA-Wireless interface. This data can then be evaluated and archived using WIKA-CAL software. Therefore, a completely paperless transmitter calibration can be achieved with the CPH7000.
Accuracy
Compensation over a wide temperature range of 10 ... 50 & deg; C (50 ... 122 & deg; F), the accuracy of this product reaches 0.025% of the range. In order to avoid complicated calculations, the measured values ​​can also be displayed directly in customer-specific units.

2019/07/26 16:05:35

927